Non-magnetic and nuclear duty: when the material list gets very short

Two requirements shorten the material list faster than anything else: no magnetism, and no cobalt. For non-magnetic disc springs and washers, CuSn8 bronze is the option, accepting considerably lower strength and spring forces. For nuclear duty, Inconel X718 is virtually cobalt free, with excellent corrosion resistance and capability to 600 degrees C. Most spring specifications […]

Retrofitting: replacing split lock and spring washers on existing plant

Replacing split lock washers on existing plant is usually a straight swap rather than a redesign. Serrated safety washers outperformed split lock, detent edged, ribbed and spring washers in Junker testing and maintained pretension force after 2,000 cycles. The three things to check before ordering are the bolt grade, the hole type and the assembly […]

Setting a slip point: disc spring stacks as torque limiters

A disc spring torque limiter works by turning axial spring force into friction torque. Slip torque follows the clamping force, so a repeatable spring load is the whole mechanism. SCHNORR components are used in sliding hubs in conveyor drives, where parallel stacking provides the force in a fixed length and load tolerance decides how tightly […]

Five reasons a bolted joint fails inspection, and what to check first

When a bolted joint keeps coming loose, the cause is nearly always one of five things: the bolt was never tightened to full preload, the locking element cannot resist transverse slip, the washer was assembled incorrectly, the bearing surface is too hard for the serrations to bite, or the wrong washer type was specified for […]